发布时间 : 星期三 文章CimatronE7.1-NC教程更新完毕开始阅读16b71d1aff00bed5b9f31d69
Hide the ReRough Toolpath and change the color of the Finish Toolpath to blue.
Cimatron E 7.1 Getting Started in NC Tutorial 37
Create a Cleanup procedure
The Cleanup procedure identifies and cleans unmachined areas that remain after previous machining operations.
From the NC Toolbar, select the Create Procedure icon Change the procedure type to Remachine/Cleanup.
Load the Preferred Values & Look for the Cleanup procedure and change the current Cutter to Ball 4.
.
38 Getting Started in NC Tutorial Cimatron E 7.1
Set the following parameters:
In the default look of the Cleanup procedure, the Previous Cutter Offset parameter is marked as hidden:
Cimatron E 7.1 Getting Started in NC Tutorial 39
When the folder display icon is shown as its parameters.
, this signifies that this folder is not displaying all
Only the parameters marked as Shown are displayed.
Hidden parameters are not displayed.
When the folder display icon is shown as parameters.
, this signifies that this folder is displaying all its
All parameters are displayed, even the ones marked as hidden.
Save & Calculate the procedure.
40 Getting Started in NC Tutorial Cimatron E 7.1