发布时间 : 星期日 文章高分子材料工程专业英语课文翻译（曹同玉，冯连芳）主编更新完毕开始阅读91ec8f2f7375a417866f8fd9
高分子专业英语选讲课文翻译资料
烯醇的溶解需要很长时间，（2）不存在饱和点，（3）粘度的增加是典型聚合物溶于溶液中的特性，这些特性主要归因于聚合物大分子的尺寸。如图1.2说明了低分子量化合物和聚合物的溶解行为。 氯化钠晶体加入到水中——→晶体进入到溶液中.溶液的粘度不是十分不同于
充分搅拌
水的粘度——→形成饱和溶液.剩余的晶体维持不溶解状态.
加入更多的晶体并搅拌
氯化钠的溶解
聚乙烯醇碎片加入到水中——→碎片开始溶胀——→碎片慢慢地进入到溶液中
允许维持现状 充分搅拌
——→形成粘稠的聚合物溶液.溶液粘度十分高于水的粘度 继续搅拌
聚合物的溶解
图1.2 低分子量化合物（氯化钠）和聚合物（聚乙烯醇）不同的溶解行为
——Gowariker VR, Viswanathan N V, Sreedhar J. Polymer Science. New York:
John Wiley & Sons, 1986.6
UNIT 2 Chain Polymerization
第二单元 链式聚合反应
Many olefinic and vinyl unsaturated compounds are able to form chain-0like macromolecules through elimination of the double bond, a phenomenon first recognized by Staudinger. Diolefins
4
高分子专业英语选讲课文翻译资料
polymerize in the same manner, however, only one of the two double bonds is eliminated. Such reactions occur through the initial addition of a monomer molecule to an initiator radical or an initiator ion, by which the active state is transferred from the initiator to the added monomer. In the same way by means of a chain reaction, one monomer molecule after the other is added (2000~20000 monomers per second) until the active state is terminated through a different type of reaction. The polymerization is a chain reaction in two ways: because of the reaction kinetic and because as a reaction product one obtains a chain molecule. The length of the chain molecule is proportional to the kinetic chain length.
Staudinger第一个发现一例现象，许多烯烃和不饱和烯烃通过打开双键可以形成链式大分子。二
烯烃以同样的方式聚合，然而，仅限于两个双键中的一个。这类反应是通过单体分子首先加成到引发剂自由基或引发剂离子上而进行的，靠这些反应活性中心由引发剂转移到被加成的单体上。以同样的方式，借助于链式反应，单体分子一个接一个地被加成（每秒2000～20000个单体）直到活性中心通过不同的反应类型而终止。聚合反应是链式反应的原因有两种：因为反应动力学和因为作为反应产物它是一种链式分子。链分子的长度与动力学链长成正比。
One can summarize the process as follow (R. is equal to the initiator radical): 链式反应可以概括为以下过程（R·相当与引发剂自由基）：略
One thus obtains polyvinylchloride from vinylchloride, or polystyrene from styrene, or polyethylene from ethylene, etc.
因而通过上述过程由氯乙烯得到聚氯乙烯，或由苯乙烯获得聚苯乙烯，或乙烯获得聚乙烯，等等。
5
高分子专业英语选讲课文翻译资料
The length of the chain molecules, measured by means of the degree of polymerization, can be varied over a large range through selection of suitable reaction conditions. Usually, with commercially prepared and utilized polymers, the degree of polymerization lies in the range of 1000 to 5000, but in many cases it can be below 500 and over 10000. This should not be interpreted to mean that all molecules of a certain polymeric material consist of 500, or 1000, or 5000 monomer units. In almost all cases, the polymeric material consists of a mixture of polymer molecules of different degrees of polymerization.
借助于聚合度估算的分子链长，在一个大范围内可以通过选择适宜的反应条件被改变。通常，通过大量地制备和利用聚合物，聚合度在1000～5000范围内，但在许多情况下可低于500、高于10000。这不应该把所有聚合物材料的分子量理解为由500，或1000，或5000个单体单元组成。在几乎所有的事例中，聚合物材料由不同聚合度的聚合物分子的混合物组成。
Polymerization, a chain reaction, occurs according to the same mechanism as the well-known chlorine-hydrogen reaction and the decomposition of phosegene.
聚合反应，链式反应，依照与众所周知的氯（气）-氢（气）反应和光气的分解机理进行。 The initiation reaction, which is the activation process of the double bond, can be brought about by heating, irradiation, ultrasonics, or initiators. The initiation of the chain reaction can be observed most clearly with radical or ionic initiators. These are energy-rich compounds which can add suitable unsaturated compounds (monomers) and maintain the activated radical, or ionic, state so that further monomer molecules can be added in the same manner. For the individual steps of the growth reaction one needs only a relatively small activation energy and therefore through a single activation step (the
6
高分子专业英语选讲课文翻译资料
actual initiation reaction) a large number of olefin molecules are converted, as is implied by the term “chain reaction”. Because very small amounts of the initiator bring about the formation of a large amount of polymeric material (1:1000 to 1:1000), it is possible to regard polymerization from a superficial point of view as a catalytic reaction. For this reason, the initiators used in polymerization reactions are often designated as polymerization catalysts, even though, in the strictest sense, they are not true catalysts because the polymerization initiator enters into the reaction as a real partner and can be found chemically bound in the reaction product ,i.e. ,the polymer, In addition to the ionic and radical initiators there are now metal complex initiators (which can be obtained, for example, by the reaction of titanium tetrachloride or titanium trichloride with aluminum alkyls), which play an important role in polymerization reactions (Ziegler catalysts) ,The mechanism of their catalytic action is not yet completely clear.
双键活化过程的引发剂反应，可以通过热、辐射、超声波或引发剂产生。用自由基型或离子型引发剂引发链式反应可以很清楚地进行观察。这些是高能态的化合物，它们能够加成不饱和化合物（单体）并保持自由基或离子活性中心 以致单体可以以同样的方式进一步加成。对于增长反应的各个步骤，每一步仅需要相当少的活化能，因此通过一步简单的活化反应（即引发反应）即可将许多烯类单体分子转化成聚合物，这正如连锁反应这个术语的内涵那样。因为少量的引发剂引发形成大量的聚合物原料（1：1000～1：10000），从表面上看聚合反应很可能是催化反应。由于这个原因，通常把聚合反应的引发剂看作是聚合反应的引发剂，但是，严格地讲它们不是真正意义上的催化剂，因为聚合反应的催化剂进入到反应内部而成为一部分，同时可以在反应产物，既聚合物的末端发现。此外离子引发剂和自由基引发剂有的是金属络合物引发剂（例如，通过四氯化钛或三氯化钛与烷基铝的反应可以得到），Z引发剂在聚
7